Hardware-made self-made high-performance embedded NAS

A brief explanation of a rough understanding of NAS on the market.

1. Brand.

There are many NAS brands in the domestic market. Among them, the largest user groups in China are Synology and QNAP.

The advantage is that the software is powerful and easy to use.

The shortcomings are equally obvious: price-specific and expensive. Quotes for 2K-4K.

The second brands are thecus, buffalo, NETGEAR, iconnect, D-link and other manufacturers. These brands are cost-effective. Especially buffalo and color card.

Talk about my familiar buffalo, his 4 disk machine, the licensed price is 1400 look, the big factory produced, the hardware said the past. But the software I think buffalo is the most irresponsible one of the many companies produced, from the web page To the system optimization, they are all done with perfunctory things, not in line with the definition of the big factory.

Let's talk about the Thecus, at the price of 3,000 to 5,000, the price is very high, please check the manufacturer's published parameters. Other manufacturers are not detailed, in my eyes, basically the shell and software UI Different.

2 performance

Most of the products in the price range of 1 thousand to 4 thousand are SoC, the American company Marvell. Among these brands, Qunhui and QNAP are the highest, basically the same. They have reached the maximum. The degree of optimization. Simply put, the same 1.6G frequency device, QNAP TS419P+ is more than the buffalo LS-QVL/E is 109MB / s than 75MB / s. (but the price comparison is 4500: 1400). Two key points of brand and performance The two brands, Qunhui and QNAP, are destined to be unacceptable to the general consumers. They can only be chosen by users who are not bad.

So, DDNAS V2 was born!!

Configuration information

Marvell 88F6282 1.6G (ready for everyone to upgrade to 2G)

512MB DDR3 1333 Memory

SATA 4 port (RAID 0, 1, 5) hard RAID engine)

ESATA 2 port

1000M (2 Gigabit Ethernet ports for redundancy or speed stacking)

USB 2.0

Minipci-E (with WIFI)

JTAG port

Serial port

12V power supply. (Full board power consumption 5.8W, onboard 3.5 inch / 2.5 inch hard disk power supply interface)

The board type is compatible with MiniITX specifications.

li ion battery cell output voltage is 4.2v highest and 3v cut off, normally called 3.6v/3.7v batttery. 
3.6V-3.7V Li-Ion/Polymer Battery Pack 
3.6V-3.7V 2000~5000mAh Battery Pack
3.6V-3.7V 5000-10Ah Battery Pack
3.6V-3.7V  10Ah-50Ah Battery Pack
3.6V-3.7V 50-100 Ah Battery Pack 
li ion vs li po, 3v Battery, aa lithium batteries, 3.7 volt battery, lithium ion vs lithium polymer, 3.6 volt battery
3.6 v aa lithium battery,li ion cell, high voltage battery, volt battery, lithium ion aa battery, 14250 battery,
er26500, 2aa battery, 3.6v battery, ls14250 battery, cell voltage, lithium ion vs polymer, 3.6 volt aa lithium battery,
3.6 v Lithium Ion Battery, 3.7 volt lithium ion battery, 3.7 battery, 3.6 volt lithium battery, 3 volt rechargeable battery,
3.6 volt rechargeable battery, lithium d batteries, Lipo Battery voltage, 3.6 volt aa battery, 3.6 volt pil,
3.2 volt battery, 3.2 volt rechargeable battery, 3.7 volt lithium battery, 3.6 lithium battery,3.2 volt solar batteries.

3v Battery

3v Battery,3v Lithium Battery,3V Rechargeable Battery,3V Polymer Battery

Asarke Industry Co., Limited , https://www.asarke-industry.com

This entry was posted in on